Flightdeck Solutions Forum Index Flightdeck Solutions
The place to meet and talk with fellow builders
 
 FAQFAQ   SearchSearch   MemberlistMemberlist   UsergroupsUsergroups   RegisterRegister 
 ProfileProfile   Log in to check your private messagesLog in to check your private messages   Log inLog in 

X Plane 10 Set Up and Testing info
Goto page Previous  1, 2
 
Post new topic   Reply to topic    Flightdeck Solutions Forum Index -> Sim-Avionics Support
View previous topic :: View next topic  
Author Message
vaidorge



Joined: 01 Aug 2011
Posts: 248
Location: France

PostPosted: Tue Nov 24, 2015 10:19 am    Post subject: Reply with quote

Hello

I have same issue. the yoke and tiller are not assigned under P3D with FSUIPC and FS control.

The only things i keep are the A/T and TRIM, Push to talk with FSUIPC.

Emmanuel
Back to top
View user's profile Send private message
vaidorge



Joined: 01 Aug 2011
Posts: 248
Location: France

PostPosted: Sat Oct 29, 2016 10:41 am    Post subject: Reply with quote

Hello

I need more help to configure Sim-Avionics with xplane :

I have severals issues that i didn't resolved even see the forum :

Last week i could start tq but after following instruction (737SimGuy), i lost everything. So i'm back to initialy but not retrieve what i did before. I'm disappointed.

The list of issues :
- Flight illusion don't run (this is the first time i did test)
- N2 up to 13.9% and stop climbing. So unable to start engine
- Externals lights don't run.
- If i put battery on and watch the 3d cockpit, the 3d cockpit is always black.
- The center tank continue to increase and seem to have no limits. Unable to force it to 0 with cdu.

Bonus without Sim-Avionics :
- The ACE yoke i couldn't assign the pitch attitude. The roll is fine.
- The tiller same issue i have red bar and can't switch to green as yoke.

I'm using xp 10.51 and x737 project v5. For x737, i tried with the v4 and same issues.


This is not won to advance. Crying or Very sad


Many thanks if you know what's going on. I'm lost.

Last information, i'm backing to fs9 and everything was correct.

Emmanuel
Back to top
View user's profile Send private message
vaidorge



Joined: 01 Aug 2011
Posts: 248
Location: France

PostPosted: Tue Nov 01, 2016 4:09 am    Post subject: Reply with quote

Hello

Nobody have the soluce?.

For tiller and yoke i bought a new joystick card and then i will connect tiller on it and assign under sima. For the yoke i hope to recover the rolling action.
Back to top
View user's profile Send private message
Display posts from previous:   
Post new topic   Reply to topic    Flightdeck Solutions Forum Index -> Sim-Avionics Support All times are GMT - 5 Hours
Goto page Previous  1, 2
Page 2 of 2

 
Jump to:  
You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot edit your posts in this forum
You cannot delete your posts in this forum
You cannot vote in polls in this forum


Powered by phpBB © 2001, 2005 phpBB Group