Flightdeck Solutions Forum Index Flightdeck Solutions
The place to meet and talk with fellow builders
 
 FAQFAQ   SearchSearch   MemberlistMemberlist   UsergroupsUsergroups   RegisterRegister 
 ProfileProfile   Log in to check your private messagesLog in to check your private messages   Log inLog in 

FSUIPC Question

 
Post new topic   Reply to topic    Flightdeck Solutions Forum Index -> FDS Support
View previous topic :: View next topic  
Author Message
FRANKY



Joined: 05 Sep 2014
Posts: 30
Location: New York

PostPosted: Thu Aug 10, 2017 11:28 pm    Post subject: FSUIPC Question Reply with quote

Hi All,

I have just finished putting my JetMax together and have a question about FSUIPC5 for P3d v4...

I have tried to set some of my calibrations and for the rudder when I set it the nose wheel either turns full right or full left ! I have tried to play with the values and got it to stay completely straight but when i reset P3d it seems the values were lost and I had to do it again but can not get the nose wheel to go straight again..... any ideas what I'm doing wrong and why the nose wheel is so out of line when I use FSUIPC to calibrate it ?

Also I dont think my throttles are going to full power after the calibration...

Any thoughts

Sorry I'm new to this so I think I'm going to have a lot of software questions....the JetMax hardware went together in a snap.

Thx
Frank
Back to top
View user's profile Send private message
Marco Eckl 777



Joined: 11 Dec 2015
Posts: 122
Location: Belp | LSZB

PostPosted: Fri Aug 11, 2017 1:45 am    Post subject: Reply with quote

Hi Frank,

did you setup a profile in FSUIPC which saves your configurations?
For the throttle you should set them up first in your game controller setup in windows, then with the JM setup utility, as last in FSUIPC. So you should get the full values!

Greetings
_________________
Marco Eckl | JetMax 777 SKTQ
FDS 777 Jetmax Flying since 06MAY2016
Sim-Avionics V1.70
FDS-777-MX-MCP
FDS-777-MX-Overhead
FDS-777-PRO-MX Pedestal
ACE 777 Proline Yoke
https://facebook.com/B777SSTDHomecockpit/
http://www.b777homecockpit.com
Back to top
View user's profile Send private message Visit poster's website
FRANKY



Joined: 05 Sep 2014
Posts: 30
Location: New York

PostPosted: Fri Aug 11, 2017 2:43 pm    Post subject: Reply with quote

Thanks Marco !

I'll work on it....
Back to top
View user's profile Send private message
kand



Joined: 03 Feb 2016
Posts: 103
Location: Buckinghamshire, UK

PostPosted: Sun Aug 20, 2017 4:00 am    Post subject: Reply with quote

I always use DIView before I do any HID calibration, it allows you to set the axis up and eliminate any noise/jerk. Its a really great piece of software

You can get it from Leo Bodnars site and there are some youtube videos explaining how to use it
Back to top
View user's profile Send private message AIM Address
Display posts from previous:   
Post new topic   Reply to topic    Flightdeck Solutions Forum Index -> FDS Support All times are GMT - 5 Hours
Page 1 of 1

 
Jump to:  
You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot edit your posts in this forum
You cannot delete your posts in this forum
You cannot vote in polls in this forum


Powered by phpBB © 2001, 2005 phpBB Group