Flightdeck Solutions Forum Index Flightdeck Solutions
The place to meet and talk with fellow builders
 
 FAQFAQ   SearchSearch   MemberlistMemberlist   UsergroupsUsergroups   RegisterRegister 
 ProfileProfile   Log in to check your private messagesLog in to check your private messages   Log inLog in 

How to adjust Rudder Trim sensitivity w FDS Trim_Module.exe

 
Post new topic   Reply to topic    Flightdeck Solutions Forum Index -> FDS Support
View previous topic :: View next topic  
Author Message
rsm2000e



Joined: 30 Oct 2013
Posts: 8
Location: United States

PostPosted: Wed Jan 14, 2015 12:06 am    Post subject: How to adjust Rudder Trim sensitivity w FDS Trim_Module.exe Reply with quote

Hi-

Love this piece, but in actual flight in Xplane 10, when I press left or right wing down momentary toggles, the plane goes into a roll. Clearly I need to adjust the sensitivity. If someone could point me at a fix, I would appreciate very much. Have the Phidgets drivers and the stand-alone EXE for the Rudder Trim. It is connected to the FDS interface board. Everything works but just too sensitive.

Rolling Eyes
_________________
Robert
Back to top
View user's profile Send private message
Jetcos



Joined: 30 Sep 2005
Posts: 1038
Location: Newmarket,Ontario

PostPosted: Wed Jan 14, 2015 8:38 am    Post subject: Reply with quote

The FDS TRIM Module only handles the rudder trim. The Ailerons are interfaced and assigned in InterfaceIT (or SYSBoard Controller) via the switches. Nothing for them in the module software.

You have X-Plane and what Avionics software? Then we can see if there are settings to adjust.
_________________
Steve Cos
Tech Support
Flightdeck Solutions (FDS)
Back to top
View user's profile Send private message Send e-mail Visit poster's website
rsm2000e



Joined: 30 Oct 2013
Posts: 8
Location: United States

PostPosted: Wed Jan 14, 2015 12:22 pm    Post subject: Reply with quote

Hi Steve. I have Sim-A single-seat. James P wired this up for me, and everything works, so all the switches on the rudder trim panel are assigned. My question is how can I make the left wing down or right wing down momentary toggles on the rudder trim panel LESS SENSITIVE? As it is now they are extreme... press one and the plane instantly goes into a barrel roll.

Thanks.
_________________
Robert
Back to top
View user's profile Send private message
Display posts from previous:   
Post new topic   Reply to topic    Flightdeck Solutions Forum Index -> FDS Support All times are GMT - 5 Hours
Page 1 of 1

 
Jump to:  
You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot edit your posts in this forum
You cannot delete your posts in this forum
You cannot vote in polls in this forum


Powered by phpBB © 2001, 2005 phpBB Group