Flightdeck Solutions

APAK · Posted: Mon Feb 13, 2017 1:00 pm Post subject: visual system

Guys ,

I have a visual system for FSX with 3 Benq projectors and a curved screen ( 180 degres ) .
I changed the place where it was installed and now I got a problem which I cannot find the root of it. when FSX is loaded only the center projector shows the three views the other two remain black .When I maximize the view , of the center projector , all three views are maximized and I have all three views maximized but I can only see the center view because the left and right projectors are like turn of. As soon as I exit the FSX all projectors work without problem.[img]

Please help me

regards

Alberto Künzel

APAK · Posted: Mon Feb 13, 2017 3:40 pm Post subject: visual system

Hi ,

After i have posted the below I have noted that when the FSX starts I loose the signal for Left and Right projector . Why ?

regards

Alberto Künzel

Jetcos · Joined: 30 Sep 2005 Posts: 1224 Location: Newmarket,Ontario

Are you using a Triple Head to Go or nVidia Surround for the projectors?

Check that the Full Screen settings in FSX match the projector resolution you need.
_________________
Steve Cos
Vice President and Tech Support
Flightdeck Solutions (FDS)

APAK · Posted: Tue Feb 14, 2017 5:23 am Post subject: visual system

Hi ,

I am using Triple Head to Go .

rgds

Alberto K6unzel

APAK · Posted: Tue Feb 14, 2017 1:54 pm Post subject: visual system

Hi Steve ,

I noted that with FS9 if I right click the mouse on the center view the right and left get signal and I have the three views. With FSX this not happen.
I already checked the FSX config and there I have in the graphic section the mode= 3072x768x32 like in setting of full screen of the FSX.

Any tip is welcome.

Regards

Alberto Kunzel