Well, I'm still having problem with my avionics PC. Finally I have decided to instal Sim-Avionics on a brand new PC I was building for other purposes; New MoBo, New processor, New RAM, New SSD, NEW graphics cards (2 GT730), Windows 10... etc.
After that, today I reinstall Sim-Avionics v1.85, now I can fine-tune PFD, EICAS, MFD and can save the new sizes and positions. BUT, I still have some other problems:
1.-On windows screen configuration setup I can see all four monitors (1 to 4) in the correct order: 1 for PFD, 2 for EICAS, 3 for CDU and 4 for MFD.
2.- BUT during Sim-Avionics software installation, and scrren setup, It shows a different ordr for the screens: 1 is ok, 2 is 3, 3 is 4 and 4 is 2... very rare.
3.- BTW, CDU screen does not turn on and shows nothing during monitor asignment
4.- Even that, I just asigned each monitor to show what each monitor have to show.
5.- After a few minutes (3-5) a windows error appears, and SimA softwares needs to be closed.
6.- The more strange thing is that even I run SimA on demo mode, neither CDU and MCP turn on...!!!
I know, as I have a new hardware I neeed to request a new activation key, so I can make a a test flight.
Mark has been helping me, before I decided to build a new PC.
Any help...? Please...!!!
JetMax 737 SKTQ
ACE B737 Yoke
Asus Maximus IX Code, CPU Intel i7, 7700K, Gskill,3200 16GB RAM, Nvidia 1080ti,
180Â° Screen, 3 Optoma GT1080 Projectors